What is the procedure for 2010ECL signal monitor ATSI test?

Procedure

1. Download and install PCMT-8800 Test Manager software.
2. Open PCMT-8800 Test Manager.
3. Go to “Monitor Info” and enter signal monitor details.
4. Go to "Test Setup" and set:
   1. Test Standard Caltrans = Model 2010
   2. Monitor Type = 18 Channel
   3. Test Type = Certification
   4. Test Laps = One
5. Open MonitorKey software and set the following:
   1. Top dip switch: 1,4,6,7 “on”

      1. All others “off” —> RF 2010, GY ENABLE, LEDguard, RF

         SSM

   2. Middle dip switch: all “on” (SSM on for all channels)
   3. Bottom dip switch: all “on” (SSM on for all channels)
   4. WD Enable: “on”
6. Insert “Regular Test Card” with all diodes soldered in.
7. Start test.
   1. Make sure you reset monitor for five seconds after setting switches).
   2. Tester will “beep” when complete.