Procedure For 2018KCL Or 2018KCLip Monitor ATSI Test

  1. Enter 2018k Monitor data into Monitor Info (serial number, etc.)
  2. On the PCMT-8000 go to “Test Setup” Test Standard Caltrans Model 2010, Monitor Type 18 Channel, Test type Certification, and Test Lap One. (see below)

  3. Insert the test Monitor Key into the unit.
  4. See below if you do not have a test key setup

  5. Start test (make sure you Reset Monitor for 5 sec after setting switches)
  6. Tester will “beep” when complete
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.