How do I set up my Reno MMU2-1600GE monitor for an ATSI test?

Procedure

1. Enter MMU2-1600GE Monitor data into Monitor Info (serial number, etc.)
2. Setup MMU2-1600GE to ATSI test:
   1. Go to Main screen push next key to “CONFIGURATION SETTINGS” hit Select key.
   2. From CONFIGURATION MENU, Move down to “Fault Monitoring Setting:” hit Enter key.
   3. From the Fault Monitoring Menu, Move down to “TESTING DEFAULTS” hit Enter key.
   4. Answer Yes to the TESTING DEFAULTS question. You should hear 3 beeps and then you are ready for testing.
3. Insert “Regular Test Card” No Jumpers.
4. Start test (make sure you Reset Monitor for 5 sec after setting switches). Tester will “beep” when complete.
5. Open the ATSI software .
6. Click on “Monitor Info” and fill it out. Hit OK.