Procedure for MMU2-1600GE Monitor ATSI Test

  1. Enter MMU2-1600GE Monitor data into Monitor Info (serial number, etc.)
  2. Setup MMU2-1600GE to ATSI test
    1. Go to Main screen push next key to “CONFIGURATION SETTINGS” hit select key
    2. From CONFIGURATION MENU, Move down to “Fault Monitoring Setting:” hit Enter key
    3. From the Fault Monitoring Menu, Move down to “TESTING DEFAULTS” hit Enterkey
    4. Answer Yes to the TESTING DEFAULTS question. The should hear 3 beeps and you are ready for testing
  3. Insert “Regular Test Card” No Jumpers
  4. Start test (make sure you Reset Monitor for 5 sec after setting switches). Tester will “beep” when complete.
  5. Open the ATSI software
  6. Click on “Monitor Info” and fill it out. Hit OK
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.